Main applications

  • Chemical industry
  • Industry engineering
  • Oil /Gas
  • Petrochemical Industry
  • Water
  • Water supply
  • Watertransport

Technical data

Q max 320.0 m³/h
H max 95.0 m


Vertical immersion pump in cantilever design for wet or dry installation. Semi-open impeller, pump shaft without guide bearings, supported by ball bearings in the upper section. Supplied with discharge pipe extending above the baseplate (CINCP) or without discharge pipe (CINCN). ATEX-compliant version available.


Chemical and petrochemical industries, raw materials extraction and waste water management.

Further technical information about CINCP / CINCN

Overview of technical data

Q (50Hz) 0.7 – 320.0 (m³/h)
H (50Hz) 3.5 – 95.0 (m)
Type of bearing Rolling element bearings
Casing partition Radially split
Drive Electric motor
Drive frequency 50 Hz /60 Hz
Type of drive Electric motor
Drive voltage Low voltage
Connection to power supply 230/400 V, 3~
Explosion protection ATEX (94/9/EC)
Type of first impeller Single entry
Maximum submergence 1585.0 (mm)
Impeller material (EN standard) CA6NM, CF8M, JL 1040
Type of coupling Direct
Type of lubrication Grease / Oil lubrication
Max. permissible fluid temperature 100.0 (°C)
Pump set location Dry installed, floodable
Shaft material (EN standard) AISI-316L, F-114
Suction characteristics Non-priming
Top plate Yes
Type of casing Volute casing
Type of impeller Open
Casing material (EN standard) CA6NM, CF8M, JL1040
Installation position Vertical
Shaft seal type Shaft seal ring
Main applications Industry and process engineering, Water
Maximum discharge-side pressure 10.0 (bar)
Maximum drive rating 184.0 (kW)
Type of installation Stationary
Maximum speed of rotation 3500.0 (1/min)