KWP

KWP


Main applications

  • Ash removal
  • Bio. treatment / 2.stage
  • Biofuels
  • Biogas
  • Breweries
  • Chemical industry
  • Cooling water and condensate
  • Desalination
  • Drainage
  • Energy
  • Flood / stormwater holding tanks
  • Flood control
  • Flue gas desulphurization (FGD)
  • Flue gas desulphurization plants (FGD)
  • Flue gas desulphurization systems (FGD)
  • Food and beverages
  • General Processes
  • Industrial Process
  • Industry engineering
  • Mech. treatment / 1.stage
  • Mineral Mining
  • Mining
  • Municipal waste water
  • Oil /Gas
  • Petrochemical Industry
  • Pipelines and Tanks
  • Power Stations < 100 MW
  • Power Stations > 100 MW
  • Process
  • Rawwater transport
  • Sewage treatment plants
  • Slurry
  • Special processes
  • Steel
  • Sugar
  • Surface drainage
  • Suspended solids treatment
  • Tank cleaning
  • Waste water
  • Waste water transport
  • Water
  • Water treatment
  • Watertransport
  • Watertreatment

Design type

Long-coupled design

Technical data

Q max 15000.0 m³/h
H max 140.0 m

Design

Horizontal, radially split volute casing pump in back pull-out-design, single-stage, single-entry, available with various impeller types: non-clogging impeller, open multi-vane impeller, free-flow impeller. Design to ATEX.

Applications

Handling of pre-treated sewage, waste water, all types of slurries without stringy substances and pulps up to 5 % bone dry with a maximum density of 1.4 kg/dm3.

Further technical information about KWP

Overview of technical data

Q (50Hz) 4.0 – 15000.0 (m³/h)
H (50Hz) 1.0 – 140.0 (m)
Type of bearing Rolling element bearings
Casing partition Radially split
Drive frequency 50 Hz /60 Hz
Type of drive Electric motor
Drive voltage Low voltage, high voltage
No. of impeller entries Single entry
Impeller material (EN standard) CERAMIKPOLYSIC, ERN, NORICHROM, NORICLOR, NORIDUR 1.4593, NORIHARD
Type of installation Long-coupled
Type of coupling Jack shaft / Belt drive, Direct, Gear
Type of lubrication Oil lubrication
Max. permissible fluid temperature 280 (°C)
Nozzle position End suction
Maximum operating pressure PN10
Pull-out design Yes
Pump set location Dry installed
Shaft material (EN standard) C45+N
Suction characteristics Non-priming
Type of casing Volute casing
Type of impeller Free flow impeller, Closed, Radial, Multi-vane impeller, Open
Type of connection Flange
Casing material (EN standard) CERAMIKPOLYSIC, JL1040, NORICLOR, NORICROM, NORIDUR 1.4593, NORIHARD
eClass assignment 36410101, 36410000, 36410100, 36410103
Free passage 250 (mm)
Installation position Horizontal
Shaft seal type Mechanical seal, Gland packing
Main applications Industry and process engineering, Water, Waste water / sewage, Energy, Mining / Dredges
Casing material Special cast material, Cast iron, Duplex steel
Maximum discharge-side pressure 10 (bar)
Maximum drive rating 1500 (kW)
Type of installation Stationary
Maximum speed of rotation 3500 (1/min)